• Robust plate for extended cycle life.
  
• Computer-generated grid design optimized for high power density.
  
• Low calcium grid alloy for reduced gas emissions and ease of recycling.
  
• Flame-arresting one-way pressure-relief vent for safety and long life.
  
• UL-recognized component.
  
• Multicell design for economy of installation and maintenance.
  
• Case and cover available in standard polypropylene.
  
• Thermally welded case-to-cover bond to eliminate leakage.
  
• Removable carrying handles.
  
• Can be used in any orientation. Upright, side, or end mounting recommended.
  
• Absorbent Glass Mat (AGM) technology for efficient gas recombination of up to 99% and freedom from electrolyte maintenance.
  
• Not restricted for air transport – Complies with IATA/ICAO Special Provision A67.
  
• Not restricted for surface transport – classified as non-hazardous material as related to DOT-CFR Title 49 parts 171-189.
  
• Not restricted for water transport – classified as non-hazardous material per IMDG Amendment 27.
  
• Dual Bi-Marine Terminal to accept ring lug and standard SAE automotive connections.

DCS-75BT - Specifications
Cells Per Unit	Voltage Per Unit	Weight	Electrolyte		Maximum Discharge Current	Short Circuit Current	Ohms Imped. 60 Hz
6	12.84	54 lbs. 25 kg.	Absorbed H2SO4 SG = 1.300		600 Amps	3100 Amps @ 0.1 sec.	0.0045 Ohms
Capacity			64.0 Ah @ 5 hour rate to 1.75 volts per cell @ 77°F (25°C).
			75.0 Ah @ 20 hr. rate to 1.75 volts per cell @ 77°F (25°C).
			68.2 Ah @ 10 hr. rate to 1.80 volts per cell @ 20°C (68°F).
Operating Temperature Range			Discharge; -40°F (-40°C) to +160°F (71°C).			Charge; -10°F (-23°C) to +140°F (60°C).(with temperature compensation)
Recommended Operating Temperature Range			+74°F (23°C) to +80°F (27°C).
Float Charging Voltage			13.5 to 13.8 VDC/unit Average at 77°F (25°C).
Recommended Maximum Charging Current Limit			C/5 amperes (15.0 amperes @ 100% depth of discharge) @ 20 hour rate.
Equalization and Cycle Service Charging Voltage			14.4 to 14.8 VDC/unit Average at 77°F (25°C).
Maximum AC Ripple (Charger)			0.5% RMS or 1.5% P-P of float charge voltage recommended for best results.
			Maximum AC ripple float charge voltage allowed = (4% PP).
			Maximum AC ripple current allowed = 3.75 amperes RMS (C/20).
Self Discharge			Dynasty batteries may be stored for up to 6 months at 77°F (25°C) and then a freshening charge is required. For higher temperatures the time interval will be shorter.
Accessories			Inter unit connectors, racks and cabinet systems are available.
Terminal			5/16-18 UNC stainless steel stud and standard SAE automotive posts.
Terminal Hardware Initial Torque			50-70 in.-lbs.; Stud post - 1/2 turn past hand tight.
Terminal Hardware Annual Retorque			40-55 in.-lbs.; Stud post - untighten then 1/2 turn past hand tight.

Return